300ztt engine pull
F5 Hero
Joined: Aug 2005
Posts: 855
From: Little Rock, Arkansas
Originally Posted by ZLover4Life
It's a b!tch if it's never been removed before and the precat heat shields are still installed. Try removing the heat shields and use either a gear wrench or a stubby wrench... I don't remember which was easier.
And get downpipes... the starter is SO much easier to install/remove with downpipes installed.
And get downpipes... the starter is SO much easier to install/remove with downpipes installed.
the starter just sucks.was following the write up on tt.net and it said remove the window heat shield off the starter, i did, and it basically did nothing, did not even need to take it off to get to the lower bolt, helped none on the top, and that heat shield was a BITCH too bc it has a bolt on top as well...
will try stubby wrench, thanks (that is what tt.net says also, just havn't gotten around to trying it yet with my return to school, + work)
*EDIT* Sorry, not trying to thread highjack =)
Registered User
Joined: Feb 2006
Posts: 459
From: Ohio
I have those cheaper downpipes,
paid 160$ for them,so far so good, no problems with them, welds are intact and they have been run hot. It's only been a couple months but summer months, i'll see how they fair after a winter.
Thread
Thread Starter
Forum
Replies
Last Post
donvito33139
300ZX (Z32) Performance / Technical
1
May 19, 2006 07:46 AM
wickedshadowz
240Z, 260Z, 280Z (S30) Forums
2
Jul 28, 2002 09:19 AM
Bookmarks
