300ZX (Z31) Performance / Technical Discussions related to Turbo charging, Supercharging, Engine, ECU, exhaust, and etc. performance enhancements and Techical related.

Engine control Fuse Blowing

Thread Tools
 
Search this Thread
 
Old Jun 18, 2006 | 11:36 AM
  #1  
Zfanatic's Avatar
Thread Starter
Registered User
 
Joined: May 2006
Posts: 6
Engine control Fuse Blowing

I have a 87 n/a. Every time I turn the key on to my car the EC Fuse blows. I know there is a short but I can't find it. I've replaced the fuseable links by the batt. because two of them burned through. but now those are fine but my EC fuse keeps blowing. Its a green and white wire that I know goes to the computer and to the Ignition coil. I just can't figure out where to look for the Short. Any Suggestions?
Old Jun 19, 2006 | 06:33 AM
  #2  
PooFlinginMonke's Avatar
Registered User
 
Joined: Mar 2006
Posts: 271
From: florida
since that wire powers the O2 sensor, Air regulator, and the coil.............I would start by unplugging all 3 and see if the fuse still blows.
Old Jul 15, 2006 | 07:49 AM
  #3  
Zfanatic's Avatar
Thread Starter
Registered User
 
Joined: May 2006
Posts: 6
It was the wires leading to the O2 sensor. They got too close to the exhaust manifold and melted together. Thanks for the help.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
DalyZX
300ZX (Z32) Performance / Technical
2
Feb 10, 2013 09:31 AM
RollinaZx
300ZX (Z32) Performance / Technical
1
Jun 17, 2009 01:42 PM
280Z4ME
The Lounge (Off Topic)
0
May 12, 2005 10:42 AM
km_in_sj
280ZX Performance / Technical
2
Dec 25, 2004 11:48 AM
hadez
300ZX (Z32) Forums
1
Dec 11, 2002 07:26 AM




All times are GMT -7. The time now is 01:29 AM.