New Enigine Rebuild. Idles but doesnt run
#1
New Enigine Rebuild. Idles but doesnt run
FRankenstien Build.
Heres my build. im having issues with the 280z crossed with 280zx conversion. After warming up the car for about 10 minutes. The engine runs strong, but then starts to drop rpm where it sounds like it wants to shut off, but catches itself again. The cycle goes over and over.
'77 N42 bottom block
'77 N42 head
all new gaskets. oil changed
'83 brand new exedy clutch system with transmission oil change
'83 intake manifold
'83 manufactured rebuilt dizzy,
'83 oil pump
'83 thermostat housing
'83 fuel pump system
'83 AFM
I have a 280zx ECU/harness installed, but should i be using a 280z ECU/harness
bash this
Heres my build. im having issues with the 280z crossed with 280zx conversion. After warming up the car for about 10 minutes. The engine runs strong, but then starts to drop rpm where it sounds like it wants to shut off, but catches itself again. The cycle goes over and over.
'77 N42 bottom block
'77 N42 head
all new gaskets. oil changed
'83 brand new exedy clutch system with transmission oil change
'83 intake manifold
'83 manufactured rebuilt dizzy,
'83 oil pump
'83 thermostat housing
'83 fuel pump system
'83 AFM
I have a 280zx ECU/harness installed, but should i be using a 280z ECU/harness
bash this
Thread
Thread Starter
Forum
Replies
Last Post
Zdrv1ven
300ZX (Z32) Performance / Technical
0
05-10-2013 06:25 PM
87z31turbo
300ZX (Z31) Performance / Technical
6
05-16-2006 07:20 PM
Bookmarks