no spark after r&r
#1
no spark after r&r
I removed my oil pump and distributor on my 83 zx turbo. this was running good before r&r. after i reassembled no spark. I Have checked everything. no spark. If it is a ground issue, what would be the likely spot? does anyone have any thoughts? Ecu seem ok.
#2
I think you left out a few details...
So, literally the ONLY things you touched were the fuel pump and distributor? Never disconnected the battery? Never unplugged ANYTHING else?
#1: Check for power at the coil: With key on, is black white stripe showing 12v?
#2: Is distributor base plug and round black harness plug securely connected?
#3: Is coil bracket securely grounded?
#4: Is ecu green light on?
I'd say you either left something disconnected, or blew a fusible link.
So, literally the ONLY things you touched were the fuel pump and distributor? Never disconnected the battery? Never unplugged ANYTHING else?
#1: Check for power at the coil: With key on, is black white stripe showing 12v?
#2: Is distributor base plug and round black harness plug securely connected?
#3: Is coil bracket securely grounded?
#4: Is ecu green light on?
I'd say you either left something disconnected, or blew a fusible link.
#3
I think you left out a few details...
So, literally the ONLY things you touched were the fuel pump and distributor? Never disconnected the battery? Never unplugged ANYTHING else?
#1: Check for power at the coil: With key on, is black white stripe showing 12v?
#2: Is distributor base plug and round black harness plug securely connected?
#3: Is coil bracket securely grounded?
#4: Is ecu green light on?
I'd say you either left something disconnected, or blew a fusible link.
So, literally the ONLY things you touched were the fuel pump and distributor? Never disconnected the battery? Never unplugged ANYTHING else?
#1: Check for power at the coil: With key on, is black white stripe showing 12v?
#2: Is distributor base plug and round black harness plug securely connected?
#3: Is coil bracket securely grounded?
#4: Is ecu green light on?
I'd say you either left something disconnected, or blew a fusible link.
thank you!
#4
#6
Thread
Thread Starter
Forum
Replies
Last Post
Fairladyz1990AF
300ZX (Z32) Forums
7
04-24-2014 04:15 PM
Knightly
240Z, 260Z, 280Z (S30) Forums
0
06-30-2013 07:34 PM
rar7775
240Z, 260Z, 280Z Performance / Technical
4
01-15-2010 06:21 PM
Bookmarks