no oil press.on 240
Thread Starter
Registered User
Joined: Apr 2003
Posts: 5
From: farmers branch, tx
no oil press.on 240
1971 240z
eng rebuilt. new bearings, rings etc.
started engine...0 oil press.
installed new oil pump. removed dist and shaft and used a drill and driver to prime pump. installed a mech oil press gauge in eng comp. ran drill for several minutes and still had 0 oil press on mech oil press ga.
removed valve cover and ran drill. oil is oozing out of cam shaft. any thoughts on where or what the problem is?
help
eng rebuilt. new bearings, rings etc.
started engine...0 oil press.
installed new oil pump. removed dist and shaft and used a drill and driver to prime pump. installed a mech oil press gauge in eng comp. ran drill for several minutes and still had 0 oil press on mech oil press ga.
removed valve cover and ran drill. oil is oozing out of cam shaft. any thoughts on where or what the problem is?
help
The Good Twin
Joined: Aug 2005
Posts: 20,639
From: Wild Wild West, UTAH!
Did you first fill the oil pump & oil filter? You'll probably never get pressure w/o priming them first:
https://www.zdriver.com/forums/showt...ime#post280013
https://www.zdriver.com/forums/showt...ime#post280013
Thread
Thread Starter
Forum
Replies
Last Post
mdharris11
300ZX (Z31) Performance / Technical
4
Dec 16, 2004 08:01 PM
Bookmarks
