I'm in dire need of some carbs for my 280. I have fuel injection issues that I have been fussing with for like 3 months and decided not to dump money into this FI system.

Some SU's would do. I'd spend a little more money on some Mikuni's or Webers, let me know what you got. Email me at boizart1@yahoo.com as I'll respond off my phone right away. I'm located in South Florida.

 

I have a full setup that I could likely part with.

 

Flat tops or round tops? Pictures? How much?

 

I have a set of round tops with everything that needs rebuild for 120. No shaft play and all manifold and heat shield parts included

 

If you are still looking I have the exact setup that you require. I too had the idea to junk the fuel injection on my 280Z and go with a set of round tops, professionally rebuilt, including all new hardware, NASCAR approved heat coating, new springs, brass fittings, you get the idea. The pictures are from another forum where I am an active member for over 5 years, you can check me out on: my350z.com, my username is on the paper in the pics.

 

YOu can either PM me if interested, these same SD round tops are also listed on: my350Z.com . I have plenty of Z car parts, from Datsun thru 350Z, soon to be a Z32 owner, crosses fingers.

http://my350z.com/forum/not-z-relate...ound-tops.html

 

If you are interested you can PM me, these same carbs were listed last summer on: my350Z.com I would like to see them getting some use, as I have not put them to use.


http://my350z.com/forum/not-z-relate...ound-tops.html

 

i have a set of triple dellortos but they need rebuilt but id give you a good deal

 

Could you PM me a price and pics? 40 or 45mm?