i found that my TPS is bad, and i'm sick of buying all these crazy expensive new parts. so if anyone has a used TPS they can sell and ship for less then OEM price, please do tell. it's for a 1990 Z32, N/A, and i'm not sure about compatability of this part, but tell me what you have and i'll look up weather it will work or not
PS: only fully functional parts please!

 

email me at willkrom554@yahoo.com if anyone not a member would like to sell me one

 

Have you checked the local junk yards / www.car-parts.com ?

 

there arn't any junk yard near me that would have a Z32 in them! lol the yards near me are 10 years behind that. but i'll check that link out. thanks a lot

 

i found a z32 at a local junk yard. where would i find this piece? if you can give me a pic and circle the thing i'll try to find it sunday.

 

Here ya go (it's on the left outside of the left throttle body):

 

what kind of material is it and another pic would help like a side shot? and if it's a pocket part then i'll just charge you shipping ok?

 

It's small... that's all I can say.

 

$27 shipped for a working one.

 

that would be spectacular! you just need to take out the 2 bolts, the 2 connectors going to it, and i think it slides right off. PM me if you really get it. that would be a great help if you could

 

ok im going in a few mins so can i have your phone number cause i don't have internet anymore.

 

also do you need the whole setup or just the thing that the yellow arrow is pointing to?

 

i found another one tonsoffun. sorry about the false alarm. but thanks a lot for the offer. seriously that almost helped me out a lot

 

thanks a lot for the quick shipping on that hoov. it works... almost... fine. good enough for me and better then the last one. it might actually be my set up that is a little off.

it didn't help the idle like i was hoping, but it did seem to improve throttle response a bit. example: going from 3/4 to WOT is a lot bigger difference then it was with the old TPS.

 

cool, did you clean that crap off the connectors?

 

yea it came off right quick. the whole job took about 1/2 an hour. i have another part that i'd like to see if you'd be willing to test and ship. it's on the back of the plenum. i'll look up the name and picture real quick. i think it has "air flow" in the name. the connector points toward the middle of the car and it's on the back left side. i know it's bad, i just don't know what it is lol

 

let me check, i have the plenum sitting on the shelf..