4BBL Holley Conversion Choke
#1
4BBL Holley Conversion Choke
How goes it guys?
I finally have all the parts to do my conversion and I've read the install at least 20 times or so now trying to get briefed on the install. But I've got one question which I have not been able to resolve through the googlez or on the forum.
What would be the best way to wire the electric choke? I've thought about just wiring a switch to it for the time being and just wiring it into the harness at a later time, but I'd rather get everything together at once.
If anyone has any experience on this or could point me in the direction of a thread of this topic, I would greatly appreciate it.
I finally have all the parts to do my conversion and I've read the install at least 20 times or so now trying to get briefed on the install. But I've got one question which I have not been able to resolve through the googlez or on the forum.
What would be the best way to wire the electric choke? I've thought about just wiring a switch to it for the time being and just wiring it into the harness at a later time, but I'd rather get everything together at once.
If anyone has any experience on this or could point me in the direction of a thread of this topic, I would greatly appreciate it.
#2
Currently reading on other forums bout different forms of vehicles and the wiring for them. It doesn't appear to be as complicated as I was making it, lol.
Still, if anyone has any pointers, just let me know.
Still, if anyone has any pointers, just let me know.
#3
All you need is a 12v from the ignition "on". It has a ground already. Ita can't over power the carb linkage so you have to press down slightly on the loud pedal. With the engine cold, power to the choke, turn the choke cover clockwise untill the butterfly closes. You can increase or decrease as desired but be sure not to have choke when warm enough.
Thread
Thread Starter
Forum
Replies
Last Post
balaguy
240Z, 260Z, 280Z Performance / Technical
2
05-07-2005 04:25 PM
Bookmarks