Hey, I posted a while back about my clutch acting up after i got my master/slave cylinder replaced. The clutch would get extremely hard to push, and eventualy would not grab, start slipping. Ive tried bleeding the line, no luck. Tried RE-REPLACING the slave cylinder, no luck. Could my prob be my master cylinder? Becuase if I open the top bleed nipple, the preasure is released and it workd fine for a while, til the pressure builds back up again, then it starts slipping and getting hard again. So its not in the trans, its in the hydrolic system. I think its a preasure prob. PLEASE HELP! THANKX!



10048-caaaaaaaar.jpg