So I have a 1990 300zx n/a auto, clean body no rust only had 1 owner, very well taken care of until the motor went. I got the car as a project to do over the next couple years.

I want to turn this into a twin turbo with a manual transmission, I already have a twin turbo engine and manual transmission that is together from another 300zx. What would I need to do to the na car to make this engine and transmission work. Twin turbo motor has wire harness and cpu. money isn’t a problem, I really want to do this project. Any and all advance guidance to get me going in the right direction. This car has sentimental value due to the person who owned it passed away. So I want to use this frame and body but remove this auto trans and na engine put in a a twin turbo and manual.

 

What is required to make the twin turbo and manual transmission work. I will already have the slave pedal and drive shaft rear end prepped and installed with inside console stick done.