I recently bought an 86 Turbo. The previous owner had left the engine harness on the exhaust and melted it along with many of the connectors on it. When I bought the car he had a wiring harness he had purchased to replace the one he had melted. I took the old harness out and put the new harness in. I believe (believe being the operative word) that I have it all hooked up correctly HOWEVER I have no spark. I took my electrical tester and tested power at the connector going into the ignition coil I have 9V there. I should at least get some kind of spark shouldn't I? I have put in a spare coil I had and a new PRW-2 that I bought. I have the coil grounded. Any ideas?