I took it all apart in a rush to get the ignition lock replaced and didn't pay attention.

Heres what I got...

2 metal plates
2 wires
4 springs (2 fat, 2 skinny)

Ok now both wires screw into the bottom plate right? do the fat or skinny springs go on the top?

Ok so what else am I missing...cause even when I put all the springs in and both plates in and hook both those wires up I don't see how the top plate contacts anything to close the circuit for the horn...I need help here...yeah I know I'm stupid for not paying more attention to it when I took it apart...Thanks oh its a 1982

 

Ok, I just went and looked at mine, but I only saw 3 springs, the 2 skinny ones were at the upper middle and the one was lower middle center. There were 4 screws holding the top plate down. Hopefully this will help, if you want I'll post a picture of it assembled in the morning (DCamera is in my truck, sorry [img]/w3timages/icons/tongue.gif[/img])

Jamie Shelly
kd5izq@msn.com
ICQ - 159705433
IZCC Number is #12402