It's a cruel world... I learned all about push through wheel centers for the mag wheels and I found a set ordered them, and installed one before lunch... perfect... not.... when I tried to install the next one, I found that the mag rim was NOT the same!!! and neither were the other two on the rear of the car... so the mag rim I measured to order the push through centers was the oddball... so I am back to square one and from what I can tell, I may need some creative thinking here.. I looked and need what are called four ear tab bolt on center caps... anybody have any experience with these or have any other alternative ideas other than painting the hubs, which I already did as part of rebuilding protocol... any suggestions welcome....thanks....