Wiring harness???
#1
Wiring harness???
I have the engine wired. It is very minimal thanks to the Mallory distributor, and Weber Carbs.
All I need now is all the wiring for the rest of the car. It was all cut out. No joke. Not sure why. So I need the wiring for the chassis of the car. Gauges, dash, heater, lights, etc.
Any idea where to get one? I can get kits through companies like Painless, but that is something that is universal, and not made for the 260Z. There is no one that sells them complete is there?
Third option is starting from scratch and making my own.
I have a fuse block, but I don't even know if it's the right one. It's nuts how much was stripped, and I wish I knew why.
All I need now is all the wiring for the rest of the car. It was all cut out. No joke. Not sure why. So I need the wiring for the chassis of the car. Gauges, dash, heater, lights, etc.
Any idea where to get one? I can get kits through companies like Painless, but that is something that is universal, and not made for the 260Z. There is no one that sells them complete is there?
Third option is starting from scratch and making my own.
I have a fuse block, but I don't even know if it's the right one. It's nuts how much was stripped, and I wish I knew why.
#4
Checked the jonk yards around me already. Mine was the only pre-'80 Z there...
I can make my own, but after I buy the stuff needed like the wires, and spend the time it might be worth buying one of those universal kits. Anyone ever installed one?
I have a wiring diagram, and a good knowledge on wiring, and electrical troubleshooting, along with my trusty Fluke 87. haha
I can make my own, but after I buy the stuff needed like the wires, and spend the time it might be worth buying one of those universal kits. Anyone ever installed one?
I have a wiring diagram, and a good knowledge on wiring, and electrical troubleshooting, along with my trusty Fluke 87. haha
Thread
Thread Starter
Forum
Replies
Last Post
Nick Napala
FS: 300ZX (90-96)
0
02-07-2014 01:55 AM
Bookmarks