are these bolts and a new gasket are all i need to change my intake/exhaust gasket?
http://www.thezstore.com/page/TZS/PROD/PEC05/15-8081

 

yup. u got headers or stock exhaust manifold?

 

stock, just trying to fix my exaust leak before i mess up a valve if i havent already

 

****!!!! is finding the bolt spacing on a z32 rear caliper so ****ING difficult!!! holy ****ing **** batman, why doesnt the ****ing factory ****ing service ****ing manual have stupid **** like this? jesus ****ing christ!!!!! and you can **** off if you thing im gonna ****ing capitalize jesus's ****ing name......holy ****.........



/vent

 

i'll go out right now and measure it if you send me that turn lamp for no charge more than shipping

 

deal, just remember to measure from the center of the hole to the center of the hole. on the mounting tabs of the calipers.

 

ok, which holes? you want a mm measurement?

 

the two mounting tabs on the bottom of the caliper, where it bolts to the spindle, mm is nice, but inches would be more usefull.

 

ok. before i go out in the cold, let me varify. all you want is the distance between those two holes that mount to the spindle?

 

let me give you a visual demonstration.

 

are you going to post it in this thread?

 

click the atachment.

 

just make sure you measure the spacing on the rear caliper though.

 

alright. i'll just take both measurements that i think you may be referring too. the picture says the spacing of caliper holes, and a previous post says spacing of where it mounts to the spindle. maybe i'll see when i get out there.

 

measure the holes on the tabs on the caliper WHICH mount to the tabs on the spindle. you measuring the spacing on the holes for the rear caliper.

 

this is what you need to do, except your using a tape measure instead of a caliper (unless you have one)

 

nevermind, i just found what i have been searching for the past two weeks....

 

damn.... i just finished finding it... 4.5 "...........

 

lol dont worry, that number is a helluva lot more accurate then the numbers in that other thread, let me have someone pull the driverside front turnsignal. and i will get your info on shipping.

 

word. was i right on? it looked like exactly that to me. but of course, i didn't have a way to find the very center of the bolt head.

 

the guy said in the thread he wasnt accurate, did you use a caliper or tape measure?

 

i used a tape measure. i really don't think calipers would have fit in there with the caliper on the car. it was pretty tight with the e-brake cable even for the ruler.

 

I don't believe in dailys

 

Well here is my current daily.

 

lol wow. ^^^^

If I had the need for a daily (I walk to work) I'd probably get something I wouldn't even tell anyone about. You know, one of those cars you run into the side rails for fun. Something I can run into a telephone pole with, fold the radiator in half, drive until it overheats, blows a gasket, looses oil pressure, shoots a rod through the hood, then get out and laugh at it. One of those cars.