Clutch Still acting Up
#1
Guest
Posts: n/a
Clutch Still acting Up
Hey, I posted a while back about my clutch acting up after i got my master/slave cylinder replaced. The clutch would get extremely hard to push, and eventualy would not grab, start slipping. Ive tried bleeding the line, no luck. Tried RE-REPLACING the slave cylinder, no luck. Could my prob be my master cylinder? Becuase if I open the top bleed nipple, the preasure is released and it workd fine for a while, til the pressure builds back up again, then it starts slipping and getting hard again. So its not in the trans, its in the hydrolic system. I think its a preasure prob. PLEASE HELP! THANKX!
10048-caaaaaaaar.jpg
10048-caaaaaaaar.jpg
Thread
Thread Starter
Forum
Replies
Last Post
club_sandwich
300ZX (Z32) Performance / Technical
2
11-17-2010 04:43 PM
Phantom
300ZX (Z32) Performance / Technical
2
06-19-2002 08:58 AM
Bookmarks