I didn't want to do a permanent installation of this harness so rather than soldering the wires I went with this option...

The S-AFCII harness prepped for install.
I've since added the appropriate jumper to the purple wire as per Gary's excellent write-up...
[ http://www.twinturbo.net/net/viewmsg...&msg_id=952406 ]




The Z's harness prepped for install




Now I just need to find a place, somewhat local, to tune it properly.

 

nice. where is it going to be installed at?

and are you going to be doing dual pop/maf?

 

Not yet. I'm pretty sure I'm running rich as indicated by; poor fuel economy; poor acceleration if I don't roll the throttle on gradually, and the @$$ end of my car being stained by the emissions from the exhaust. So I want to get it tuned.

 

How about a DoolZ set-up Barry? Updates?
BTW, nice to see you here.

 

Hey John,

No plans for any more mods. Not right away anyway

The AFC is currently plugged in, and I should be going to a dyno in March to get the it dialed in.

I'll post the charts when it's done.