injector retainer torque
#5
Do you know or could u find the torque rating for the 5 upper intake manifold bolts? I have been looking in the fsm! I can find the lower manifold torque rating, but not the upper. I'm tightening my injector retainers to 3 1/2 pounds I won't listen to the fsm for that one cause they seemed to leak from the factory tightening! I don't think that's to much!
#7
I think the FSM calls the upper manifold the intake collector. Torque is listed at 13 to 16 ft lbs. It's tough to find because it's listed in the Engine Fuel/Emission Control section. All torque settings in the FSM are listed as tables among the last few pages of each section. Torque values also are presented in some of the schematics (look for a symbol of a wrench head followed by 3 sets of numbers).
Thread
Thread Starter
Forum
Replies
Last Post
280zExTURBO
280ZX Performance / Technical
8
10-09-2005 09:13 PM
Bookmarks