lets see if theres life in this dead message board.

i finally have a matching set of 6 new injectors i pulled from cars in washington that have been worked on but never fixed aparently. i got 2 sets of 5 injectors and i manage to get a set of 6 that are the same.

they all test out with good resistance, and all of them are clean.

i got a set of injector connectors aswell off of another car some time ago, the squeeze type so i am going to replace them aswell but i was wondering.

when i solder the new connectors on do i need to pay attention as to the order of the wire on each connector or will they just work if both of them are hooked up?

 

i would, just to be safe. i dont recall keeping mine in order when i replaced them, just to be on the safe side i would in the future though.